BMC - TrueSight IT Data Analytics extractor

BMC Helix Capacity Optimization supports integration with TrueSight IT Data Analytics (ITDA) through the BMC - TrueSight IT Data Analytics extractor, that imports ITDA entities into BMC Helix Capacity Optimization.

The versions of TrueSight IT Data Analytics that are supported are 1.0, 1.1, 2.0, and 2.1.

For more information, see the following sections: 

• • Integration steps
  • Metrics and entity types

Integration steps

To integrate BMC Helix Capacity Optimization with the BMC - TrueSight IT Data Analytics extractor, perform the following task:

1. Navigate to Administration > ETL & SYSTEM TASKS > ETL tasks.
2. In the ETL tasks page, click Add > Add ETL under the Last run tab.

3. In the Add ETL page, set values for the following properties under each expandable tab.

   • Basic
   • Advanced

   
   

   Note

   Basic properties are displayed by default in the Add ETL page. These are the most common properties that you can set for an ETL, and it is acceptable to leave the default selections for each as is.

   Basic properties

   • • ===

   Note

   To view or configure Advanced properties, click Advanced. You do not need to set or modify these properties unless you want to change the way the ETL works. These properties are for advanced users and scenarios only.

   Advanced properties
4. Click Save.
   You return to the Last run tab under the ETL tasks page.
5. Validate the results in simulation mode: In the ETL tasks table under ETL tasks > Last run, locate your ETL (ETL task name), click  to run the ETL.
   After you run the ETL, the Last exit column in the ETL tasks table will display one of the following values:
   • OK: The ETL executed without any error in simulation mode.
   • WARNING: The ETL execution returned some warnings in simulation mode. Check the ETL log.
   • ERROR: The ETL execution returned errors and was unsuccessful. Edit the active Run configuration and try again.
6. Switch the ETL to production mode: To do this, perform the following task:
   1. In the ETL tasks table under ETL tasks > Last run, click the ETL under the Name column.
   2. In the Run configurations table in the ETL details page, click  to edit the active run configuration.
   3. In the Edit run configuration page, navigate to the Run configuration expandable tab and set Execute in simulation mode to No.
   4. Click Save.
7. Locate the ETL in the ETL tasks table and click  to Run it, or schedule an ETL run.
   After you run the ETL, or schedule the ETL for a run, it will extract the data form the source and transfer it to the BMC Helix Capacity Optimization database.

Metrics and entity types

The following details are fetched from ITDA for a Saved search that is imported into Capacity Optimization as a business driver of type "Business Driver - Generic".