Worksheet to configure disaster recovery for Infrastructure Management (SAP SQL Anywhere)
The following table lists the steps that you must perform to configure a Infrastructure Management disaster recovery system. Use the table to record the required disaster recovery information and confirm actions. This information will help you perform a seamless configuration of disaster recovery setup.
Worksheet to configure disaster recovery setup
Decision or requirement | Your entry |
|---|---|
| Configure the DNS server | |
| Specify an alias name for the primary BMC TrueSight Infrastructure Management Server. | |
| Configure the primary BMC TrueSight Infrastructure Management Server | |
| Edit the hosts file with an entry for the alias name set for the primary BMC TrueSight Infrastructure Management Server. | |
Record the following parameters. You must enter the same ones during installation of recovery server:
| |
| Enable Disaster Recovery Mode. | |
| (Windows only) For the BMC TrueSight Infrastructure Management Server service and the Infrastructure Management Database Engine service, set the Startup type to Manual. | |
| Configure the remote event cells | |
To flush and reset the cache, open a command prompt on a remote event cell and run the following command:ipconfig /flushdns | |
| Restart the remote event cell, and similarly, configure all the remote event cells. | |
| Configure the recovery BMC TrueSight Infrastructure Management Server | |
| Stop the primary BMC TrueSight Infrastructure Management Server. | |
Use the same entries that you configured for the primary BMC TrueSight Infrastructure Management Server:
| |
| Enable Disaster Recovery Mode. | |
On the recovery BMC TrueSight Infrastructure Management Server, edit the hosts file with an entry for the <aliasName>that is the same alias name as the one on the primary server. | |
| (Windows only) For the BMC TrueSight Infrastructure Management Server service and the Infrastructure Management Database Engine service, set the Startup type to Manual. | |
| Restart the computer with the recovery BMC TrueSight Infrastructure Management Server. | |
| Stop the recovery BMC TrueSight Infrastructure Management Server. | |
If the following processes are running on your computer, end them:
| |
| Copy the entire \pw directory from the primary BMC TrueSight Infrastructure Management Server to the \pw directory of the recovery BMC TrueSight Infrastructure Management Server. | |
| Move all the log files from \pw\pronto\logs to a backup directory. | |
| Start the recovery BMC TrueSight Infrastructure Management Server and validate the configuration. | |
| Stop the recovery BMC TrueSight Infrastructure Management Server. | |
| Restart the primary BMC TrueSight Infrastructure Management Server. On the primary server, run the pw system start command. | |
| Back up the database files and configuration files at regular intervals | |
| Back up configuration files. | |
| Back up KB files files. | |
| Back up cell database files. | |
| Back up database files. |
Was this page helpful? Yes No
Submitting...
Thank you
Comments
Log in or register to comment.