Installing Process Designer remotely

Before you begin

Make sure that you completed the installation steps given on Performing BMC Remedy ITSM Process Designer installation.

For a fresh install of Process Designer, perform all these steps in the order listed.

Upgrade from a version of Process Designer earlier than 8.3.02 is not supported. Contact BMC support for assistance.

To install the Process Designer

1. Create a new folder with name ProcessDesigner in bmc folder on your AR System server. For example, /opt/bmc/ProcessDesigner.
   Assign this folder read/write/execute permissions for all users.
2. Extract the <<Installer_Launcher_Location>>\Disk1\files\ shared_Components.zip file.
3. Copy ARID.jar and abyd-server-lib.jar files into plugins directory.
4. Update the AR Configuration files with details of the new plug-ins.
5. The ar.conf and pluginsvr_config.xml files must refer to the two plug-ins that Process Designer uses at runtime. The config.txt file, contained in ProcessDesignerServerFiles.gzip, contains templates for the additional entries.

   1. Navigate to ar.conf (usually in <AR install dir>/CONF) and copy the following lines from the config.txtfile:

      Server-Plugin-Alias: ABYDOS.ARID.FILTERAPI ABYDOS.ARID.FILTERAPI <servername>:<port>

   2. Replace <servername>:<port> in this template entry with the details from your server.
      <servername> is the name of your server and <port> is the port used by the server plug-in, usually 9999.
      For example:

      Server-Plugin-Alias: ABYDOS.ARID.FILTERAPI ABYDOS.ARID.FILTERAPI localhost:9999
   3. Save the modified ar.conf file.
   4. Locate the pluginsvr_config.xml file (default location is <AR install dir>/pluginsvr).

   5. Replace {ARID Configuration Path} with the full path to your ARID folder, as created in step 1 (for example, opt/bmc/ARID).
      For example:

      <plugin>
      <name>ABYDOS.ARID.FILTERAPI</name>
      <classname>com.abydosworkflow.designer.arid.ARPlugin</classname>
      <filename>D:\BMCSoftware\BMCARSystem\pluginsvr\processdesigner\ARID.jar</filename>
      <pathelement type="location">D:\BMCSoftware\BMCARSystem\pluginsvr\processdesigner\abyd-server-lib.jar</pathelement>
      <userDefined>
      <server_name>stack1-2s</server_name>
      <server_port>46262</server_port>
      </userDefined>
      </plugin>

      Note

      Delete ABYDOS.ARF.ARADMINPASS plugin entries, if any.

6. Restart the AR System server.
   You must restart your AR System server for these changes to take effect, and for the plug-in to be initialized.
7. Restart the AR System service
   To make sure that the ARID plug-in loads the updated configuration entry, restart the AR System service to re-initialize the plug-in. The ARID plug-in should now be operational.

Where to go from here

Configuring the ARID plug-in and BMC Remedy ITSM Process Designer runtime settings from the BMC Remedy ITSM online documentation.