mkill
Use the mkill command to stop a running cell or gateway.
mkill syntax
The following figure shows the syntax for mkill.
mkill syntax
[-n <cellName> | -n @Host[/Port[#Key]]]
[-l <HomeLocation>][-v] [-s]
If you do not specify a cell to stop, this command stops the default cell, Host.
You must use the -ncellName option on multiple cell hosts.
The following table lists the command-specific option for mkill. For a list of common command options that apply to all CLI commands, see Event-management-common-command-options.
mkill option
Option | Description |
|---|---|
-s | Performs rapid shutdown termination; bypasses StateBuilder |
mkill example
The following figure shows an example of mkill:
Example of mkill
The preceding command produces output similar to the example shown in the following figure:
Output of mkill
mkill return codes
There are no command-specific return codes for mkill. For a list of common return codes that apply to all CLI commands, see Event-management-return-codes.