Unsupported content This version of the documentation is no longer supported. However, the documentation is available for your convenience. You will not be able to leave comments.

Manually switching the Infrastructure Management application to the secondary server

If you want to switch the Infrastructure Management application to the secondary server in the cluster, you can switch manually by using the following command:
clresourcegroup switch [-n node] resource_group

  • -n node specifies the name of the server on which the resource group is to be switched.

    Note

    The Infrastructure Management application switches to the next available secondary server if you do not specify the -n node.

  • resource_group specifies the name of the resource group of the node to which you are switching.

    For example:
    clresourcegroup switch -n atlantic pnbmc_rg

     This command switches the Infrastructure Management application to the standby node, atlantic, from the primary node in the pnbmc_rg resource group.

Related topics

Installing-Infrastructure-Management-in-high-availability-mode

Configuring-the-BMC-TrueSight-Infrastructure-Management-Server-in-Sun-Cluster

Running-Infrastructure-Management-in-high-availability-mode

Disabling-failover-for-Infrastructure-Management

Configuring-high-availability-remote-cells-for-viewing-in-the-Operations-Console

Setting-up-the-cluster-in-Linux

Setting-up-the-service-to-run-in-high-availability-mode-in-Linux

Bringing-a-resource-group-online

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*