Starting and stopping cloud topology consuming
By default, consuming cloud topology is enabled and the integration is configured to start automatically when you install Infrastructure Management. However, you may want to stop it to make configuration changes and then restart it again.
To start or stop the service:
- Open a command prompt.
Type in the command:
pw cloudTopologyIntegration on|off -a <adaptertype>Where:
-a <adaptertype> - child adaptertype or ALL. adaptertype must be the same as specified in CloudAdapter.xml.
You can use the pw cloudtopologyintegration list command to list all adaptertypes registered to cloud publishing in the CloudAdapter.xml file.
If the integration on or off commands fail, check the following:
- In the CLMAdapter.xml file, make sure that <clm-url>, <clm-password>, and <clm-username> properties are set correctly.
- In the Pronet.conf file, make sure that the adapter is enabled as described in Enabling-cloud-topology-consuming-in-Infrastructure-Management.
Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*