syslogparams (command)

Remote logging is a utility that uses numerical severity values to log system events.

Logging messages can be sent to a log-collection system that you have configured. For Performance Analytics Engine instances, you cannot configure remote logging through a web interface, so you must use the CLI and the syslogparams command.

Remote logging commands

Use the following commands to enable, disable, configure, and display the system log information.

Commands for remote system logging

 

Logging levels

You can send a range of logging messages to the log-collection system. By selecting a logging level, you designate the level of severity of the logs that are sent to the log-collection system. Emergency (0) is the highest severity of logs, and debug (7) is the lowest severity. For example, if you select warning (4), only logs with a level of warning or higher (emergency, alert, critical, and error) are sent to the system.

Remote system logging levels

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*