Monitoring Watchpoints via the Console

Note

To monitor Watchpoints from the

The macro unmigrated-inline-wiki-markup from Confluence is no longer available.

, you must have the Watchpoints plug-in enabled on your Console instance. To do this, contact the BMC support representative.

The Administration > Watchpoints page displays the list of all Watchpoints from the

The macro unmigrated-inline-wiki-markup from Confluence is no longer available.

components that are associated with the Console instance.

Every Watchpoint is described with the following parameters:

  • Status — Marks the Watchpoint as enabled or disabled. You cannot change the Watchpoint status from the Console. You can enable or disable a Watchpoint only from the

    The macro unmigrated-inline-wiki-markup from Confluence is no longer available.

    component that holds the Watchpoint.
  • Name and description — These parameters are entered during the Watchpoint creation, and they can only be edited from the corresponding

    The macro unmigrated-inline-wiki-markup from Confluence is no longer available.

    component.
  • Component Name — The name and the IP address of the

    The macro unmigrated-inline-wiki-markup from Confluence is no longer available.

    component where the Watchpoint has been created.

As you add new components to the Console, their Watchpoints are automatically added to the list. When you create a new Watchpoint on a component that is already connected to the Console, it is automatically added to the list.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*