Adding an incident detection rule

To manage incidents, you must add a rule that triggers incidents when the system detects abnormal behavior in your web traffic.

To add an incident-detection rule

1. In a

   The macro unmigrated-inline-wiki-markup from Confluence is no longer available.

   component, point to Administration > Threshold and problem detection and click Incident detection.
2. On the Action menu, click Add.
3. In the Name box, type Performance for MyBillingApplication.
4. In the Watchpoint list, type a name for the rule.
   
   For example, if you have a Watchpoint called MyBillingApplication that identifies traffic for your billing application and you want a performance rule to create incidents when too many pages violate their SLTs, you could type Performance for MyBillingApplication.
5. For Type, select the type of rule that you want to create:
   • Performance — The incident will trigger each time when system detects too many pages violating Service Level Thresholds (SLTs)
   • Availability — The incident will trigger each time when system detects an abnormally high percentage or errored requests
      You can customize, which errors the system monitors for incidents
   • Volume — The incident will trigger each time when system detects an abnormally high or low number of requests
     
     Select Performance.
6. To activate the rule immediately after creation, leave the Activate box selected.
7. To edit advanced settings for this rule, click Next and proceed to Configuring-advanced-detection.
   
   The following tabs open:
   • Detection — Controls the amount of incidents to detect, depending on the data volumes.
   • Analysis — Specifies additional criteria for analyzed traffic to isolate the root causes.
   • Notification — Specifies the incident criticality and notification parameters.
8. Click Save.

Where to go from here

Configure advanced detection parameters.

Related topics