Decompressing the Installation System image

Use the following procedure to decompress the Installation System image:
  1. After successfully obtaining the Installation System image and decompression job, edit the decompression JCL data set (<INSTDCMPDatasetName>) according to the instructions in the job.

    Important

    The decompression JCL contains a job within a job that is submitted to the internal reader.

  2. Submit the edited JCL to decompress the Installation System image.

    Decompressing the Installation System image creates the following installation libraries:

    • HLQ.BMC.INSTALL
    • HLQ.BMC.INSTALL.LOAD
    • HLQ.BMC.POZBOOT
  3. Continue to Starting the Installation System.


Was this page helpful? Yes No Submitting... Thank you

Comments

  1. Rick Ugaz

    BMC STOP TRYING TO OVER SIMPLIFY A BASIC INSTALL. THESE SILLY FLOW CHARTS DO NOTHING. HERE'S AN IDEA: PROVIDE A MANUAL WITH STPES TO FOLLOW! GOOD GRIEF.

    May 31, 2024 03:14
    1. Jyoti Birajdar

      Hello, Rick.

      Thank you for taking the time to share your valuable feedback with us.

      Regarding your mention of flowcharts, the content on this page primarily consists of step-by-step instructions rather than flowcharts. However, we have now updated step 3 in this topic, which points to the next logical step.

      Additionally, you referred to oversimplification. If you think that there is information missing from this page, please do not hesitate to inform us, and we will try to update it. Your insights are helpful in our efforts to improve the documentation.

      Once again, thank you for your feedback.

      Regards,
      Jyoti

      Jun 03, 2024 08:30