Page tree

Unsupported content

 

This version of the documentation is no longer supported. However, the documentation is available for your convenience. You will not be able to leave comments.

Skip to end of metadata
Go to start of metadata

By default, consuming cloud topology is enabled and the integration is configured to start automatically when you install Infrastructure Management. However, you may want to stop it to make configuration changes and then restart it again.

Note

The integration will start only if you enabled it in the pronet.conf file.

To start or stop the service:

  1. Open a command prompt.
  2. Type in the command:
    pw cloudTopologyIntegration on|off -a <adaptertype>
    
    Where:
    -a <adaptertype> - child adaptertype or ALL. adaptertype must be the same as specified in CloudAdapter.xml.
    You can use the pw cloudtopologyintegration list command to list all adaptertypes registered to cloud publishing in the CloudAdapter.xml file.

    Example

    pw cloudTopologyIntegration on adaptertype
    pw cloudTopologyIntegration off adaptertype
    

If the integration on or off commands fail, check the following: