Worksheet to configure disaster recovery for Infrastructure Management (Oracle)
The following table lists the steps that you must perform to configure a Infrastructure Management disaster recovery system. Use the table to record the required disaster recovery information and confirm actions. This information will help you perform a seamless configuration of disaster recovery setup.
Worksheet to configure disaster recovery setup
Decision or requirement | Your entry |
---|---|
Configure the DNS Server | |
Specify an alias name for the primary TrueSight Infrastructure Management Server. | |
Configure the primary TrueSight Infrastructure Management Server | |
Edit the hosts file with an entry for the alias name set for the primary TrueSight Infrastructure Management Server. | |
Record the following parameters. You must enter the same ones during installation of recovery server:
| |
Enable Disaster Recovery Mode. | |
(Windows only) For the TrueSight Infrastructure Management Server service, set the Startup type to Manual. | |
To flush and reset the cache, open a command prompt on a remote event cell and run the following command:ipconfig /flushdns | |
Restart the remote event cell and similarly configure all the remote event cells. | |
Configure the recovery TrueSight Infrastructure Management Server | |
Use the same entries that you configured for the primary TrueSight Infrastructure Management Server:
| |
Enable Disaster Recovery Mode. | |
On the recovery TrueSight Infrastructure Management Server, edit the hosts file with an entry for the <aliasName> that is the same alias name as the one on the primary server. | |
(Windows only) For the TrueSight Infrastructure Management Server service, set the Startup type to Manual. | |
Restart the computer with the recovery TrueSight Infrastructure Management Server. | |
Stop the recovery TrueSight Infrastructure Management Server. | |
If the following processes are running on your computer, end them:
| |
Copy the entire \pw directory from the primary TrueSight Infrastructure Management Server to the \pw directory of the recovery TrueSight Infrastructure Management Server. | |
Move all the log files from \pw\pronto\logs to a backup directory. | |
Start the recovery TrueSight Infrastructure Management Server and validate the configuration. | |
Stop the recovery TrueSight Infrastructure Management Server. | |
Stop the Oracle Database instance. | |
(If applicable) Configure disaster recovery for Infrastructure Management Reporting Engine with Oracle Data Guard | |
Back up configuration files. | |
Back up KB files. | |
Back up cell database files. | |
Back up Oracle Database files. |
Was this page helpful? Yes No
Submitting...
Thank you
Comments
Log in or register to comment.