configureanomaly CLI command
Use this command to enable or disable anomaly detection. Though anomaly detection is enabled by default, if you are upgrading from a previous TrueSight IT Data Analytics version, in such instances the settings that you have specified regarding anomaly detection, will be carried forward to the upgraded version of TrueSight IT Data Analytics. You can use the configureanomaly CLI command to enable or disable anomaly detection.
Before you run the command, note the following points:
- Set up the CLI. For more information, see Managing the product from the command line interface.
- Prefix this command with the following, as appropriate:
- For Windows: itda.bat
- For Linux: ./itda.sh
Angle brackets (< >) indicate a variable value that needs to be user defined.
Square brackets ([ ]) indicate optional parameters.
The following table describes the parameters used in the syntax:
|Host name of the Console Server.
|Port number of the Console Server.
|User name to use to connect with the Console Server.
|Password corresponding to the user name to use to connect with the Console Server.
The operation that you would like to carry out.
It can take the following values:
(optional)The time interval at which you want the anomaly detection calculations to take place. It is expressed as the interval in seconds. The interval cannot be less than 300 seconds.
The default interval is 900 seconds.
The following example provides the input for enabling anomaly detection:
The following example provides the input for disabling anomaly detection:
The following example provides the input for retrieving the status of anomaly detection (enabled/disabled):