Starting and stopping cloud topology consuming
By default, consuming cloud topology is enabled and the integration is configured to start automatically when you install Infrastructure Management. However, you may want to stop it to make configuration changes and then restart it again.
The integration will start only if you enabled it in the pronet.conf file.
To start or stop the service:
- Open a command prompt.
- Type in the command:
pw cloudTopologyIntegration on|off -a <adaptertype>
-a <adaptertype>- child adaptertype or ALL. adaptertype must be the same as specified in CloudAdapter.xml.
You can use the
pw cloudtopologyintegration listcommand to list all adaptertypes registered to cloud publishing in the CloudAdapter.xml file.
pw cloudTopologyIntegration on adaptertype pw cloudTopologyIntegration off adaptertype
If the integration on or off commands fail, check the following:
- In the CLMAdapter.xml file, make sure that <clm-url>, <clm-password>, and <clm-username> properties are set correctly.
- In the Pronet.conf file, make sure that the adapter is enabled as described in Enabling cloud topology consuming in Infrastructure Management.