Configuring after installation

After you install PATROL for SAP HANA, you must load the Knowledge Module (KM) into the TrueSight Console and configure the product so that it can obtain parameter data from the SAP HANA.

TaskLink
Configuring in a BMC ProactiveNet Performance Management environmentSee BMC ProactiveNet documentation.
Configuring in BMC TrueSight environmentSee BMC TrueSight Infrastructure Management documentation

To begin using BMC PATROL for SAP HANA, you might need to perform additional configuration on specific consoles. For more information about additional configuration tasks, see the following topics:

SAP HANA Direct connection setup

Was this page helpful? Yes No Submitting... Thank you

Comments