Disabling and enabling data collection for an individual SID or CCMS Context

You can disable data collection for an individual discovered SAP system or CCMS Context, and subsequently re-enable data collection at any time. After disabling an SAP system or CCMS Context, you can remove the item from display in the PATROL Console.

To disable data collection

  1. From the PATROL Console work area, right-click one of the following existing nodes, depending on the level that you are interested in:

    Node

    Disable level

    SAP system (SSM_SID_CONT)

    Data collection for the discovered SAP system and all CCMS Contexts under it.

    CCMS Context (SSM_CONTEXT_CONT)

    Data collection for the discovered CCMS Context and all performance-type CCMS parameters under it.

  2. Select KM Commands > Data Collection > Disable.
  3. If you want to cancel automatic discovery for the SAP system or CCMS Context, select the Cancel automatic discovery check box in the Confirmation message.
    If you do not cancel automatic discovery, all data collection is enabled once again the next time the SAP Solution Manager system is discovered.
  4. Click Yes in the Confirmation message.

To remove a disabled item

  1. From the PATROL Console work area, right-click a disabled SAP system or CCMS Context node.
  2. Select KM Commands > Data Collection > Remove.
  3. Click Yes in the Confirmation message.

To enable data collection

  1. From the PATROL Console work area, right-click a disabled SAP system or CCMS Context node.
  2. Select KM Commands > Data Collection > Enable.
Was this page helpful? Yes No Submitting... Thank you

Comments