Attribute and parameter properties
The following table describes the default attribute (parameter) properties available in PATROL, ProactiveNet and TrueSight console.
Collector and text parameters do not display the ProactiveNet Performance Management properties.
Default parameter properties
The application class under which this parameter is displayed.
Language used to create the command this parameter executes.
Example: PATROL Script Language (PSL)
Specifies whether the parameter is represented as a graph, text box, stop light (signal), or boolean state.
Specifies the unit of measure in which the parameter output is expressed, such as a percentage, a number, or bytes.
Indicates the normal operating range for the parameter. The Border range must be larger than the Alarm1 and Alarm2 ranges combined.
Values are described as less than and greater than, for example <0 or >100.
If the Border range is undefined, it means it is inactive and any values that appear are not intended as recommendations.
Specifies the thresholds for the first-level alarm; this is not applicable to collector parameters.
Specifies the thresholds for the lower numerical values deemed unacceptable for this parameter. Values must be lower than values for Alarm2; cannot overlap Alarm2 range or fall outside the Border range. Values falling inside this range trigger warnings, alarms, or recovery actions.
If undefined, Alarm1 is inactive, and any values that appear are not intended as recommendations.
Specifies the thresholds for the second-level alarm; this is not applicable to collector parameters.
Specifies the thresholds for the higher numerical values deemed unacceptable for this parameter. Values must be higher than the values for Alarm1; cannot overlap Alarm1 range, or fall outside the Border range. Values falling inside this range trigger warnings, alarms, or recovery actions.
If undefined, Alarm2 is inactive, and any values that appear are not intended as recommendations.
Scheduling (poll time)
Specifies how frequently the parameter will run and collect data (polling cycle); this is not applicable to consumer parameters.
Active at installation
Specifies whether a parameter is active by default; reflected in the words yes or no.
Indicates the parameter type:
Value set by
Lists the collector parameter that sets the values for the consumer parameter described.
TrueSight console/ BMC Helix Operations Management properties
|Monitor Type||The monitor type under which this attribute is displayed.|
Key Performance Indicator
|Indicates if the attribute is a Key Performance Indicator (KPI). KPIs are attributes that have the most impact on the health and performance of your environment and your service-level agreements.|
Monitor for abnormalities
Indicates whether abnormalities should be detected automatically. This applies to all attributes for which alarm ranges have been defined. If you want an attribute to be monitored for abnormalities, you should define the alarm ranges.
Indicates whether the attribute value should be plotted on the graph by default when the Show Graph is selected on the ProactiveNet user interface.
Indicates whether the parameter monitors the availability of the resource.
Indicates whether the parameter monitors the response time of an action or operation.
Indicates whether the attribute has data with extreme spikes which makes developing a normal range band difficult.
Indicates if the value collected by the attribute is numerical and indicates performance data.
Log in or register to comment.