Adding and configuring a data source

As a tenant administrator, you can add a data source to fetch data from other data stores in your environment.

Perform the following steps to add a data source:

  1. In BMC Helix Dashboards, go to Configuration > Data Sources.
  2. Click Add data source.
  3. Hover your mouse over any data source except the enterprise plugins and click Select to add the data source in BMC Helix Dashboards.

    Important: Enterprise plugins not supported

    You cannot install and configure enterprise plugins by using BMC Helix Dashboards.

  4. Depending on the data source type that you added, add the required details to configure the data source.
  5. Click Save & Test to complete the configuration.
Was this page helpful? Yes No Submitting... Thank you

Comments