Command and syntax reference
This section describes the command list.
You can modify the following commands for the receiver:
Command | Description | ||||||
|---|---|---|---|---|---|---|---|
DISPLAY(STATS) OR STATS | Displays the number of z/VM SMF records sent to the agent and lists the listeners and their status. CZAT0043I Modify Command STATS CZAT0002I Module IP address Port Listener name Status CZAT0002I CZATLVMR 172.24.48.132 8192 VMRACF ACTIVE CZAT0002I CZATLVMS 172.24.48.132 8182 VMCON ACTIVE CZAT0002I CZATLVMS 127.0.0.1 8196 VMSECURE CZAT0104I ------------------------------- Statistics ---------------------------- CZAT0104I VER 2.9.01.0054, CPU 001BA8173906, Stats reset 19193 09:57:57 CZAT0105I CZATRECV CPU TIME USED .03544 CZAT0104I VMRACF 17 CZAT0104I VMCON 676 CZAT0043I Modify Command STATS CZAT0002I Module IP address Port Listener name Status CZAT0002I CZATLVMR 172.24.48.132 8192 VMRACF ACTIVE CZAT0002I CZATLVMS 172.24.48.132 8182 VMCON ACTIVE CZAT0002I CZATLVMS 127.0.0.1 8196 VMSECURE ACTIVE CZAT0104I ------------------------------- Statistics ---------------------------- CZAT0104I VER 2.9.01.0054, CPU 001BA8173906, Stats reset 19193 10:09:02 CZAT0105I CZATRECV CPU TIME USED .03751 CZAT0104I VMRACF 17 CZAT0104I VMCON 764 CZAT0104I VMSECURE 0 The last entry at the end of the message shows the listener status as listed in the following table:
| ||||||
DISPLAY(PARMS) OR PARMS | Displays parameter entries in effect If you refreshed your parameters, the display shows the refreshed parameters. | ||||||
DISPLAY(LISTENER) OR LISTENER | Displays a list of listeners with their IP addresses and port statuses This list is in the same format as display stats. | ||||||
SETIMER(020000) | Sets the time to interval reporting, every HHMMSS For example,
| ||||||
DELETEL(listenerName) | Deletes the specified listener | ||||||
STARTL(listenerName) | Starts or restarts the specified listener Enter the name of the listener to get started. | ||||||
STOPL(listenerName) | Stops the specified listener or connection | ||||||
REFRESH (listenerName) | Causes the receiver to use the parameters from the refreshed list You must start the listener after the refresh is done to initiate the changes in the list. | ||||||
REFRESH | Refreshes the parameter list | ||||||
P task name | Shuts down |