ETIME

Use the ETIME command to specify the ending time of the processing interval on the date that you specified in the EDATE command.

RMF and SMF records with data that fall completely or partially within the Start Time/End Time period are processed by UIE.

Syntax

ETIME hhmm

Syntax explanations

  • hh is the ending hour of the interval. Specify this number by using a value from 00 to 24.
  • mm is the ending minute of the interval. Specify this number by using a value from 00 to 59.

Rules

If you do not issue the ETIME command, the default value is midnight at the end of the end date, which is denoted by the value 2400.

Note

If a numeric offset value was specified for the GMTOFF parameter in the SDATE command to indicate the local time zone, then the time that you enter in the ETIME command is considered to be local time.

Examples

ETIME 0100 (1 A.M.)
ETIME 2400 (midnight of the end date, the default)
ETIME 1200 (noon)
ETIME 2330 (11;30 P.M.)

Related topic

Command-and-syntax-reference

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*