Skip to Content

Installing the CICS exit program

This section describes how to install the CICS exit program (SOPCUSxx),which is necessary to include or exclude CICS transactions from optimization with the ULTRAOPT Monitor.

Warning

Note

If you do not need to exclude data streams from optimization based on CICS transaction names, you do not need to perform this task.

The tasks to install the CICS exit program are as follows:

  1.  Update the system initialization parameters. Depending on existing parameters, this step might not be required. For more information, see Task 1—Updating System Initialization Parameters .
  2.  Define program resources. For more information, see Task 2—Defining Program Resources.
  3. Add the SOPCINIT program to the Program List Table Program Initialization (PLTPI). Attempting to include or exclude CICS transactions without the CICS exit SOPCINIT in the PLTPI table will generate unpredictable results. For more information, see Task 3—Updating the Program List Table Program Initialization.

Repeat each task for every CICS system on which the exit program runs.


Related topics

CICS-exit-program

Installing


 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*

ULTRAOPT 4.2