Initiating auto maintenance

Auto maintenance can be started in several ways:

  • by issuing the RES command from the CREGAGT view

    The RES command can be used when updating MainView for CICS modules that run in the CICS address space only. The RES command initiates the TERM and then the INIT functions for the target CICS systems. In addition, the TRM and INT commands can be used individually, instead of the RES command.

  • at BBI-SS PAS restart

    When the BBI-SS PAS terminates, it is detected by MainView for CICS in the CICS system and a TERM function is initiated. When the BBI-SS PAS restarts, a request to INIT MainView for CICS is sent to the target CICS systems through the External CICS Interface facility (EXCI). The EXCI facility is also used to send the action commands from the CREGAGT view to the CICS system.

  • by issuing the FST2 TERM/INIT sequence from the console, a CICS terminal, or MainView AutoOPERATOR EXEC

    For more information, see Controlling-functions-manually.

  • by issuing the FST2 RES sequence from the console, a CICS terminal, or MainView AutoOPERATOR EXEC
  • when MainView for CICS is started in the program list table (PLT)

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*