CONFIG,DIAG (keyword) command

Use the CONFIG, DIAG console command to cause the configuration component to snap diagnostic data.

If the DIAG keyword of the command indicates DUMP, MainView SRM snaps all current configuration information. If the DIAG keyword contains a value other than DUMP, MainView SRM snaps diagnostic information related to the specified volume serial (VOLSER) or device address. Use this command only at the request of BMC Customer Support.

This command has no default value. Only one configuration DIAG can run at a time. If a DIAG is attempted while another DIAG is active, an error message is written to the log and the request is rejected.

The following abbreviations are valid for the CONFIG,DIAG console command:

  • D (DIAG)
  • C (CONFIG)

Example

 

SVOS CONFIG,DIAG(DUMP)
SVOS C,D(DUMP)
SVOS C,D(WORK01)
SVOS C,DIAG(WORK02)
SVOS C,D(85A0)

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*