Limited supportBMC provides limited support for this version of the product. As a result, BMC no longer accepts comments in this space. If you encounter problems with the product version or the space, contact BMC Support.BMC recommends upgrading to the latest version of the product. To see documentation for that version, see BMC AMI Ops Infrastructure 7.1.

Starting a CAS

This topic describes how to start a CAS.

To start a CAS

Note

The CAS must be run as a started task. Refer to the topic, Creating-the-CAS-startup-procedure, for instructions on preparing a CAS startup procedure and defining cross-system communication between CASs on multiple systems.

  1. Verify that the JCL for the CAS started task procedure exists.
    Creating-the-CAS-startup-procedure describes the JCL for creating the CAS started task procedure. By default, the CAS started task procedure that is created during the installation configuration is called BBMCAS. Your site might have defined a different CAS procedure name and library.

  2. From the operator console, enter the START command.
    S procname[.id][,SSID=ssid][,REUSASID=YES][,parm,parm,...]

    See CAS-START-command-parameters for a description of the variables in the START command.

  3. Look for the following console message that confirms that the CAS was started successfully:
    BBMZA001I CAS(casname)SSID(ssid)INITIALIZATION COMPLETE - Vv.r.m(modID)

This section contains the following topics :

Related topic

Managing-the-coordinating-address-space-CAS

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*