Job Optimizer commands

Job optimization requires processing from both the MainView Batch Optimizer Subsystem and Job Optimizer components. Commands provide control to these components and enable you to display status information about them. You can enter any of these commands from the operator console or from any facility that emulates an operator console.

Because MainView Batch Optimizer operates as a subsystem, status changes that are made by commands that are entered from the operator console are active only until the next IPL.

When the MainView Batch Optimizer Subsystem is started after an IPL, the previous default overrides are lost. New overrides must be entered using the commands. To prevent the need to reenter the MainView Batch Optimizer Subsystem or Job Optimizer commands, you can place them in the MainView Batch Optimizer Subsystem commands member BCSCMDxx. They will be issued from this member each time the MainView Batch Optimizer Subsystem is started.