Skip to Content

Dynamic UCBs

This application handles device addresses that have been dynamically configured into the system.

This application also recognizes when a dynamic I/O configuration change has taken place and displays the new configuration the next time you press Enter or the PF7/8 keys.

Warning

Note

If a command is issued against a device in the list while an I/O configuration change is occurring, the command will be rejected and a message appears in the short message field in the upper right corner. This application also recognizes when a dynamic I/O configuration change has taken place and displays the new configuration the next time you press Enter or the PF7/8 keys.

To reduce the overhead, the TAPE STATUS/Control application does not PIN the UCBs it displays. Therefore, if you use this application during dynamic reconfiguration processing, you might receive an 0C4 abend. This abend is a very rare occurrence and does not merit using the overhead that is required to circumvent the situation.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*

MainView AutoOPERATOR 8.2