Enabling ARM support

To enable ARM support, edit the BBPARM member BBISSP00 and specify

ARMPOLCY=[NO|YES|xxxxxxxx]

where valid values are

  • NO: specifies that the BBI-SS PAS will not use the ARM facility; the default setting

  • YES: specifies that the BBI-SS PAS will use the ARM default restart policy

    The default ARM restart policy is that ARM will restart an abended address space up to three times within five minutes. If the address space fails to restart after the third attempt, a message is written to the SYSLOG and the address space remains unstarted.

  • xxxxxxxx: Specifies a 1- to 8-character name of a user-created policy to be used to control BBI-SS PAS restarts

When you have completed modifying the ARMPOLCY parameter, restart the BBI-SS PAS. Either a warm start or a cold start will cause the new ARM policy to be recognized.

The MainView Customization Reference describes how to implement ARM support during manual customization.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*