Dynamically implementing new settings with the Activate command
The Dynamic Parameter Manager Activate line command can be used to dynamically change the BBPARM members currently in use by a BBI-SS PAS without restarting the BBI-SS PAS.
The command is specified on the main Dynamic Parameter Manager panel (see example in Access-the-Dynamic-Parameter-Manager). The following figure shows an example of the the Confirm Parameter Activation panel that is displayed after you enter the Activate line command.
Confirm Parameter Activation panel
COMMAND ===> TGT --- BBSYSA
DATE --- YY/MM/DD
TIME --- 11:43:13
Current TARGET: SYSB
Current SSID: AO22
Last Parm: AAOEXP00 (Values may have been temporarily modified)
Replaced by: AAOEXP00
Last update: YY/MM/DD 11:42
User: MXY1
Instructions:
Press ENTER to confirm activation request.
(The parameters in the current SS will be dynamically updated)
Press END to cancel activation request.
Automation is suspended briefly while the BBPARM member is read and new control blocks are built. Other products operating in the target BBI-SS PAS continue to operate.
Descriptions of the fields on this panel follow:
Field name | Description |
|---|---|
Current Target | is the ID of the current target |
Current SSID | is the ID of the current BBI-SS PAS |
Current Parm | is the name of the member of BBPARM that was used to build the current parameters in the BBI-SS PAS |
Replaced by | is the name of the BBPARM member you want to use to build the new set of parameters in the BBI-SS PAS |
Last update | is the date and time of the last change to this member |
User | is the user ID that made the last change to this member |