Starting and stopping the SERVICE REFRESH CYCLE

You can start and stop the SERVICE REFRESH CYCLE.

To start the cycle

Enter the GO command (F6/18).

To stop the cycle

Press the attention interrupt key (ATTN for SNA terminals and PA1 for non-SNA terminals).When the cycle stops, the last display shown is reissued and returned to the screen in INPUT mode.

You can analyze the status and make additional requests for other displays as usual. When you press F3, the display returns to the SERVICE REFRESH CYCLE application and shows the service names, parameters, and any short messages.

To restart the cycle

Press F6 or type GO to restart the cycle.Each refreshed service display is shown in the sequence and time (DTIME) specified. For the example shown in Creating-cyclic-displays-with-CYCLE-SETUP, the IMF MFSUT application is displayed first, followed by the MainView for DB2 DUSER application, the DA application of the MainView AutoOPERATOR MVS option, and the MainView for CICS FILE application. The cycle repeats again, starting with IMF MFSUT.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*