Creating cyclic displays with CYCLE SETUP

Use the CYCLE SETUP option to specify 10 or fewer cyclic displays.

The SERVICE REFRESH CYCLE panel is shown in Figure 1.

Figure 1. SERVICE REFRESH CYCLE panel

BMC Software -- - --------- SERVICE REFRESH CYCLE ------ GENERAL SERVICES
COMMAND ===>                                              TGT ===> CICSPROD
                                                           PAGE     1 OF 1
                        TARGET   TYPE    DTIME LOG   DESCRIPTION
SERVICE ===> MFSUT     IMSPROD IMS       3          MFS POOL UTILIZATION
   PARMS ===>
SERVICE ===> DUSER     DB2A     DB2       3          DETAIL USER STATUS
   PARMS ===>
SERVICE ===> DA        SYSA     MAO       3          DISPLAY ACTIVE
   PARMS ===>
SERVICE ===> FILE      CICSPROD CICS      5          FILE DISPLAY
   PARMS ===> * OPEN
SERVICE ===> STAT      CICSP    CICS      3          SYSTEM STATUS
   PARMS ===>
SERVICE ===>
   PARMS ===>
SERVICE ===>
   PARMS ===>
SERVICE ===>
   PARMS ===>
SERVICE ===>
   PARMS ===>
SERVICE ===>
   PARMS ===>

The input fields are defined as follows.

Input field	Description
SERVICE	service select code, such as ALERTS or EMA Note If other products are installed, services and target types (AO, CICS, CAO, IAO, IMS, DB2, or MAO) can be intermixed. The available service select codes are listed in Specifying-application-names-in-CYCLE-SETUP.
TARGET	one- to eight-character identifier of the target If TARGET and TYPE are not specified, the target displayed in the TGT field is used. If TARGET is not specified but TYPE is, the current target for the specified product line is used.
TYPE	type of product line to process the requested service A product line type does not need to be entered when only one product line is installed. If a product line is not specified, the product line where CYCLE was invoked is used. When multiple product lines are installed, a product line type must be specified if the service to be requested does not belong to the active product line.
DTIME	the number of seconds the specified service display is to be shown before the next display If a time is not entered, the default specified by the INTERVAL parameter in the BBPROF data set member BBITSP00 is used and displayed in the DTIME field. The BMC Software distributed value is 3 seconds. If the maximum of 30 services is specified, each with a display time (DTIME) of 3 seconds, the first service in the refresh cycle is displayed approximately every 90 seconds.
LOG	for IMF and MainView for DB2 services Enter a Y (YES) or N (NO) to log screen images to the BBI-TS Image log for offline printing. The default, N, is displayed if no entry is made. A dash (–) displayed in this field indicates that Image logging is not supported for the requested service.

Creating cyclic displays with CYCLE SETUP

On this page