Skip to Content

Using scroll commands

MainView AutoOPERATOR provides scroll commands that operate similarly to the way IBM ISPF scroll commands operate.

Use these scroll commands in MainView AutoOPERATOR applications and General Services.

To scroll up or down

  1. On the COMMAND line, specify the amount that you want to scroll.

    COMMAND line

    Press F7/19 to

    Press F8/20 to

    M or MAX (Maximum)

    scroll to the top

    scroll to the bottom

    1 to 9999 (number)

    scroll x lines up

    scroll x lines down

    H (Half)

    scroll half page up

    scroll half page down

    P (Page)

    scroll full page up

    scroll full page down

    Warning

    Note

    These commands do not work with the F keys F10/22 (scroll right) and F11/23 (scroll left). For these keys, the amount scrolled is not displayed.

    Success

    Tip

    You can also scroll to the top or the bottom of the data by entering the TOP command or BOTTOM command and pressing Enter:

    COMMAND ===> TOP

    COMMAND ===> BOT

  2. Press the UP key (F7/19) or DOWN key (F8/20).

To scroll left or right

In some applications (for example, the General Service LOG DISPLAY), you can scroll to the left and right.

  1. On the COMMAND line, enter the number of columns that you want to scroll.

  2. Press F10/22 to scroll to the left, or F11/23 to scroll to the right. 

    Warning

    Note

    Scrolling to the left displays the origin or point of entry for each message on the Journal log.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*

MainView AutoOPERATOR 8.2