Copying or moving Rules between Rule Sets

To use the copy or move commands between Rule Sets:

  1. From the Automation Control Panel, select an ENABLED Rule Set.
  2. From the Rule Set Overview panel, select a Rule or a block of Rules to copy or move.
  3. Place the Copy | C | CC or Move | M | MM commands next to the Rules in the LC column.
  4. Press PF3/End to return to the Automation Control panel.
  5. Select the Rule Set (on the same target) to copy or move the Rules to.
  6. On the Rule Set Overview panel, enter the After | A or Before | B line commands depending on where you want to copy/move the Rules from the first Rule Set to this Rule Set.
  7. This Rule Set must have at least one Rule already in it where you can enter the After | A or Before | B line commands.
  8. Press Enter.The Rules are copied/moved to the new location.
  9. Press PF3/END.The Confirm Rule Set Modifications panel is displayed:
  10. To save the copied or moved Rules, enter SAVE; the Rules are copied or moved.
    • If you choose to cancel any pending moves or copies, use the Reset primary command.
    • If you are copying Rules, entering SAVE saves the Rules to the copied to Rule Set and leaves a copy in the copied from Rule Set.
    • If you are moving Rules, entering SAVE saves the Rules to the moved to Rule Set and removes them from the moved from Rule Set.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*