Implementing TapeSHARE

This section describes how to implement the TapeSHARE for MainView AutoOPERATOR component. Some steps are optional.

TapeSHARE runs in a BBI-SS PAS and an image can have only one BBI-SS PAS where TapeSHARE is installed. Steps 1 and 2 are required and they must be performed on every BBI-SS PAS within the TapeSHARE PLEX.

Note

To use TapeSHARE, you must make sure the z/OS Allocated/Offline Device Exit is not specified on any image where TapeSHARE will run. TapeSHARE is defined dynamically as an Allocated/Offline Device Exit to z/OS when it initializes.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*