Dynamically implementing new settings with the Activate command
The Dynamic Parameter Manager Activate line command can be used to dynamically change the BBPARM members currently in use by a BBI-SS PAS without restarting the BBI-SS PAS.
The command is specified on the main Dynamic Parameter Manager panel (see examples in Access-the-Dynamic-Parameter-Manager and Modifying-ALERT-thresholds-in-AAOALSxx.)
Figure 1 shows the Confirm Parameter Activation panel that is displayed after the Activate line command is entered.
Figure 1. Confirm Parameter Activation panel
BMC Software ------------- Confirm Parameter Activation ---------- AutoOPERATOR
COMMAND ===> TGT --- BBSYSA
DATE --- YY/MM/DD
TIME --- 11:43:13
Current TARGET: SYSB
Current SSID: AO22
Last Parm: AAOEXP00 (Values may have been temporarily modified)
Replaced by: AAOEXP00
Last update: YY/MM/DD 11:42
User: MXY1
Instructions:
Press ENTER to confirm activation request.
(The parameters in the current SS will be dynamically updated)
Press END to cancel activation request.
COMMAND ===> TGT --- BBSYSA
DATE --- YY/MM/DD
TIME --- 11:43:13
Current TARGET: SYSB
Current SSID: AO22
Last Parm: AAOEXP00 (Values may have been temporarily modified)
Replaced by: AAOEXP00
Last update: YY/MM/DD 11:42
User: MXY1
Instructions:
Press ENTER to confirm activation request.
(The parameters in the current SS will be dynamically updated)
Press END to cancel activation request.
Automation is suspended briefly while the BBPARM member is read and new control blocks are built. Other products operating in the target BBI-SS PAS continue to operate.
Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*