Using program function (PF) key definitions in MainView AutoOPERATOR
A set of program function (PF) key definitions is maintained for each BMC Software product line and the General Service LOG DISPLAY application, so that PF key usage is unique to each product. You can use the following procedure to modify PF key definitions.
To modify PF key definitions
Perform one of the following operations:
- Use the General Service KEYS option.
Enter KEYS on the COMMAND line of the current application, and use the displayed panel to make changes.
An input panel is displayed that shows the current default values, as shown in Figure 1.
Figure 1. Program function keys panel
COMMAND ===>
The current PF Key assignments for BBI are as follows:
PF1 ===> HELP
PF2 ===> SPLIT
PF3 ===> END To save changes
PF4 ===> PRINT into profile,
PF5 ===> EXPAND enter SAVE on
PF6 ===> GO the command line.
PF7 ===> UP
PF8 ===> DOWN
PF9 ===> SWAP
PF10 ===> LEFT
PF11 ===> RIGHT
PF12 ===> RETRIEVE
When executing under ISPF, these labels may be displayed using PFSHOW
PF1 LABEL ===> PF2 LABEL ===> PF3 LABEL ===>
PF4 LABEL ===> PF5 LABEL ===> PF6 LABEL ===>
PF7 LABEL ===> PF8 LABEL ===> PF9 LABEL ===>
PF10 LABEL ===> PF11 LABEL ===> PF12 LABEL ===>
Press ENTER to display keys 13 - 24. Enter END command to EXIT.
The initial values as distributed by BMC Software are displayed. Twenty-four keys can be defined. This first panel displays the current values for the first 12 keys. Press Enter to display the current values for keys 13 through 24, as instructed on the screen.