Skip to Content

Accessing iCap (windows-mode interface)

The procedure for accessing 

iCap

 in windows mode varies slightly based on whether you are using 

MainView

. Use one of the following procedures.

To access iCap in windows mode (if using MainView)

  1. On the MainView Selection Menu, select O (Cost Optimization).
  2. On the BMC Cost Optimization Selection Menu, select 1 (BMC Intelligent Capping for zEnterprise).The EZICAP menu is displayed (Overview-of-the-EZICAP-menu).

To access iCap in windows mode (if not using MainView)

  1. Run the MCO CLIST.
  2. On the BMC Cost Optimization Selection Menu, select 1 (BMC Intelligent Capping for zEnterprise).
  3. If you are not connected to the CAS, select the CAS SSID for iCap from the displayed list of CAS regions.The EZICAP menu is displayed (Overview-of-the-EZICAP-menu).
  4. If not already connected to the system that is running the iCap master PAS, you can switch to that system in one of the following ways:
    • Type PLEX on the COMMAND line and press Enter. Then select the iCap master PAS from the displayed list.

    • Type CONTEXT PASName on the COMMAND line and press Enter.

      Warning

      Example

      CONTEXT DYCJ connects to the PAS running in the context DYCJ.

Related topic

Accessing-iCap


 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*

Intelligent Capping for zEnterprise 3.0