Skip to Content

EXCLUDE89 command

If you are authorized, IBM permits you to use the special Exclude control statement to direct SCRT to exclude the processing of certain data that is reported on SMF and SCRT89 records.

The EXCLUDE89 command permits you to specify intervals to exclude from Peak R4HA calculation. You can exclude intervals with abnormal activity that can affect the MLC sub-capacity cost.

You can exclude records for:

  • All LPARs and MLC products
  • A specific list of LPARs and MLC products

If you have excluded records in your cost data, you can use the following methods to specify the EXCLUDE89 command:

Warning

Note

If you have previously specified EXCLUDE89 commands in the UIE JCL, BMC recommends that you replace all of these commands in the Model Builder Task.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*

Cost Analyzer for zEnterprise 2.3