Limited supportBMC provides limited support for this version of the product. As a result, BMC no longer accepts comments in this space. If you encounter problems with the product version or the space, contact BMC Support.BMC recommends upgrading to the latest version of the product. To see documentation for that version, see BMC AMI Ops Monitor for CMF 6.3.

General control statements

General control statements are valid only when placed at the beginning of the control statement set. These statements specify general data selection and reporting parameters for the Analyzer; the information from these control statements applies to all report requests in the control statement set.

General control statements can appear in any order within the general control statement group, except for positional general control statements. The DATETIME, CYCLE, and PERIOD control statements are positional, and must appear in that order.

A command error results if these commands are not entered in this sequence (see DATETIME, CYCLE, and PERIOD).

This section contains the following topics:

Related topic

Analyzer-control-statements



 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*