Skip to Content

Default language.

Controlling the availability of dynamic thresholds

To make a dynamic threshold available for use, the threshold selection definition, threshold set definition, and calendar period definition must all be enabled. Any status other than ENABLED means the definition is not currently available for use.

For a dynamic threshold to take effect, one of the calendar periods specified in the threshold selection definition must be active. By default, a time-based calendar period is active when the current time and day of the week fall within one of the time spans specified in a calendar period definition that is enabled. A MANUAL calendar period is controlled by view or operator command.

Related topic

Managing-dynamic-thresholds

Use the following procedures to:

  • Enable or disable dynamic threshold definitions
  • Change the current state (active or inactive) of a calendar period

To

Do this

Enable or disable calendar period definitions

  1. Display the CALDEFS or CALDEF view.
  2. Use the ENAble or DISable primary or line command, as appropriate.

Enable or disable threshold set definitions

  1. Display the THRSETS or THRSET view.
  2. Use the ENAble or DISable primary or line command, as appropriate.

Enable or disable threshold selection definitions

  1. Display the THRSELS or THRSEL view.
  2. Use the ENAble or DISable primary or line command, as appropriate.

Change the state of a calendar period

  1. Display the CALSTAT view.

  2. Use the ACTivate or INActivate line command, as appropriate.

    Warning

    Important

    A MANUAL calendar period remains in the state that you set until someone changes the state by using the appropriate line command on CALSTAT or an operator command.

    A time-based calendar period remains in the state that you set until one of the time spans specified in its definition changes the state. Using the ACTivate or INActivate line command on a time-based calendar period is a temporary measure.


 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*

BMC AMI Ops Infrastructure 7.1