Default language.

Creating the started task for the DBC address space

Use the following procedure to set up a started task procedure for the  () address space, which is required for the .

Tip

This task is required for all 

 products.

Use XXSAMP member DBC$STC as a model to help you set up the started task procedure.

Related topics

Logger-library-members

Manual-customization

Before you begin

The  requires that a  address space is running in the LPAR. If a  address space is already running, you can skip this section and proceed to the Defining-Next-Generation-Logger-and-Logger-agents section. If a  address space is not already running in the LPAR, complete the procedure below.

To create the started task procedure for the  address space

  1. Copy XXSAMP member DBC$STC to SYS1.PROCLIB or another system procedure library.
  2. Follow the instructions at the top of the member to modify the procedure to your site requirements.
  3. (Optional) Define the  started task procedure to your IPL procedure so that the  address space starts at system initialization. For more information about the , see .
  4. Start the  started task.
  5. Proceed to Defining-Next-Generation-Logger-and-Logger-agents.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*