Limited supportBMC provides limited support for this version of the product. As a result, BMC no longer accepts comments in this space. If you encounter problems with the product version or the space, contact BMC Support.BMC recommends upgrading to the latest version of the product. To see documentation for that version, see BMC AMI Ops Infrastructure 7.1 .

Adding the BMC load library to your system link list

Use the following procedure to add the BMC load library, hlq.BBLINK, to your system link list. BBLINK contains authorized programs.

Tip

This task is optional for all products.

Before you begin

Keep the following considerations in mind:

  • IBM requires that any data sets that are added to your system link list be cataloged in the master catalog.
  • If you want to run COMMON STORAGE MONITOR (CSM) as a subsystem, you must perform this task.
  • BBLINK should be placed after your SAS/C runtime libraries in the system link list.
  • If BBLINK is added to the system link list when starting IMS, the AOI exits are dynamically invoked if BMC AMI Ops Automation is installed, regardless of whether BMC AMI Ops Automation for IMS is activated.

  1. Add the following line to your SYS1.PARMLIB(LNKLSTxx) member:hlq.BBLINK,

    Use the samehlq (high-level qualifier) that you used for your target libraries during the installation process.

  2. In the BMC AMI Ops startup procedures (such as the CAS and PAS started task procedures), remove the STEPLIB DD statement for hlq.BBLINK.
  3. Update your system link list dynamically.

Related topic

Manual-customization


 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*