Example 2: creating a Rule where MLSEG Minor = SINGLE

In this example, an IMS MLSEG message is processed by the Rule where each MLSEG segment can cause the Rule to fire because MLSEG Minor ===> SINGLE is specified on the Selection Criteria panel.

This example Rule fires based on the message ID of the major segment and additional information from the minor messages. The following IMS MLSEG message is the same as the message used for Example-1-creating-a-Rule-with-MLSEG-Minor-ALL.

To create a Rule where MLSEG Minor = SINGLE

Fill in the Selection Criteria - IMS panel as follows:
BMC Software ------------- Selection Criteria - IMS ------------ BMC AMI OpsA
COMMAND ===>                                                 TGT --- NS7A

        Rule-set === AAORUL01             Rule-id === DFS2503W

Text Description:
Text ID     ===> DFS2503W                          First word of message
Text String (Enter Below):


Issuer Identification:
Job name    ===> IMS11PRD                          Jobname of IMS
Type        ===>                                   (JOB, STC, or TSO)
Jobclass    ===>                                   Job class of issuer
Acct Info   ===>                                   Job accounting information
RACF User   ===>                                   RACF Userid
RACF Group ===>                                   RACF Group name
MLSEG Minor ===> SINGLE                            All/Single





Press ENTER to continue, END return to Detail Control, CANCEL to cancel changes
When MLSEG Minor ===> SINGLE is specified, each individual line of an IMS multisegment message is processed by the Rule as separate events. BMC recommends that you use the variables &LINE2_WORDn variables on the Variable Dependencies panel so that the Rule can fire based on specific content of the MLSEG.
Important
When creating a Rule for a IMS MLSEG message, the Rule compares the selection criteria values to the content of only the first line (major segment) of the MLSEG.
With the &LINE2_WORDn variable, LINE2 resolves to each and every segment of the MLSEG and a WORDn variable resolves for each word of each line of the MLSEG.
Press Enter the Variable Dependencies - IMS panel is displayed as shown in the following figure.

BMC Software ------------ Variable Dependencies - IMS ---------- BMC AMI OpsA
COMMAND ===>                                                 TGT --- NS7A

       Rule-set === AAORUL01             Rule-id === DFS2503W
                                                                           OR/
Variable-name                    Op Variable-Value                      AND

LINE2_WORD3:1:4_________________ EQ BE2P_______________________________ AND
LINE2_WORD6_____________________ EQ 1708_______________________________ ___
________________________________ __ ___________________________________ ___
________________________________ __ ___________________________________ ___
________________________________ __ ___________________________________ ___
________________________________ __ ___________________________________ ___
________________________________ __ ___________________________________ ___
________________________________ __ ___________________________________ ___
________________________________ __ ___________________________________ ___
________________________________ __ ___________________________________ ___
________________________________ __ ___________________________________ ___
________________________________ __ ___________________________________ ___
________________________________ __ ___________________________________

--> ATTENTION: Use ASV command to add ASV criteria to the rule <--

Press ENTER to continue, END return to Detail Control, CANCEL to cancel changes

Example 2: creating a Rule where MLSEG Minor = SINGLE

To create a Rule where MLSEG Minor = SINGLE

On this page