Invocation for DB2RESP solution
DW0120W (nn) hh:mm: AVG ELAPSED TIME(parm) = nnn (>ppp) *****
DW0150W (nn) hh:mm: AVG ELAPSED IN DB2(parm) = nnn (>ppp) *****
DW0180W (nn) hh:mm: AVERAGE CPU USED(parm) = nnn (>ppp) *****
DW0190W (nn) hh:mm: AVERAGE CPU IN DB2(parm) = nnn (>ppp) *****
DW0150W (nn) hh:mm: AVG ELAPSED IN DB2(parm) = nnn (>ppp) *****
DW0180W (nn) hh:mm: AVERAGE CPU USED(parm) = nnn (>ppp) *****
DW0190W (nn) hh:mm: AVERAGE CPU IN DB2(parm) = nnn (>ppp) *****
where
parm {ALL|IMS|CICS|TSO}
To get these messages out of BMC AMI Ops Monitor for Db2, you must activate some monitors as listed in member DPE002B of the BBPARM data set. This activation is done in BBPARM member BBIISPxx by using the TARGET statement, as shown in BBIISPD1 of BBPARM.
For example, to set the Db2 monitors, specify the following command:
TARGET=DB2D,BLK=DPE002B,USRID=xxxxxxx
You should adjust the WVAL values to values appropriate to your installation. Information about WVAL values can be found in the 'Set Timer Request' section of the BMC AMI Monitoring for Db2.
DB2RESP processes warning messages with an identifier of IMS, CICS, TSO, or ALL. These identifiers are required and cannot be modified.
Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*