VTAM TERMINALS
Use the VTAM TERMINALS panel to check the status of all terminals known to this VTAM. Like the display shown for the D NET,CLSTRS command, the scrollable list shows the LUNAMEs, the owning major nodes, types of units, and the status of the units.
Use primary commands to scan the list for a specific unit or display units in a particular STATUS. Use line commands to change the status of a NODENAME, just as if you were at the main console.
The fields or columns are defined here.
Column | Description |
|---|---|
UNITNAME | Name given to the terminal by the installation system programmer |
MAJNODE | Name of the owning VTAM node |
TYPE | Node types are defined as follows:
|
ATTACH | Indicates the type of line (LEASED or SWITCHED) that connects one node to another or the CUA address |
STATUS | Lists the VTAM status abbreviations |
See "Resource Status Codes" in the IBM documentation VTAM Messages and Codes for definitions of these status abbreviations.
Line commands for the VTAM TERMINALS application
Enter the following commands in the LC column next to the resource you want to modify.
Line command | VTAM equivalent |
|---|---|
A(ct) | V NET,ACT,ID= unitname |
I(nact) | V NET,INACT,ID= unitname |
F(orce) | V NET,INACT,ID= unitname,TYPE=FORCE |
(i)M(mediate) | V NET,INACT,ID= unitname,TYPE=IMMED |
D(isplay) | D NET,ID= unitname |
D(isplay)E(very) | D NET,ID= unitname,E |