Specifying a Final Action for an ALERT
The following figure shows an example of the Alert Escalation Final Action Type panel that is displayed when you enter a question mark in the Final Act ( ) field.
Use this panel to select the final action that an ALERT should take when it reaches its final priority level and display additional panels where you can specify the action and any additional associated keywords.
COMMAND ===> TGT --- KMZ2
Command:
Line Commands: (S)elect
Type Description
_ EXEC REXX EXEC or CLIST
_ MVS MVS/JES command
_ BBI BBI Control command
_ IMS IMS command
_ IMP IMS Plex command
_ CICS CICS command
_ MQ IBM MQ command
_ NV NetView command
_ TOM TOM command
Press ENTER to continue filling in command. END to return to Alert Actions
with selected command type, CANCEL to cancel selection.
The following figure shows an example of the REXX Exec or CLIST panel. This panel is displayed when you select EXEC from the preceding figure.
COMMAND ===> TGT --- AOAO
EXEC/Parms ==>
Priority and Delay keywords apply to all execs
Priority ===> (Norm, High, hoT, First, Single, Xsingle; default
is Norm)
Delay ===> (Seconds to wait before scheduling the exec)
Note: Total length of all input values must be less than 255 characters.
Press END to return with exec(s), CANCEL to cancel selection.
The following figure shows an example of the MVS Commands from BBI-SS panel. This panel is displayed when you select MVS from the preceding figure.
COMMAND ===> TGT --- AOAO
Command ===>
Command ===>
Command ===>
Command ===>
Command ===>
Console, Command and Response Token, and Delay keywords apply to all commands:
Console ===>
CART ===>
Delay ===>
Note: Total length of all input values must be less than 255 characters.
Press END to return with command(s), CANCEL to cancel selection.
Refer to Alert-Action-s-II-fields for more information about the fields on these panels.