Extract and FTP WLM policy

  1. Go into WLM – panelid IWMAPLGO.

  2.  Enter “2” equal to: “2. Extract definition from WLM couple data set”.
  3. On resulting panelid IWMAP01, pull down the “File” menu.
  4.  Enter “5” equal to: “5. Print”.
  5. After seeing the message “Output written to ISPF list data set  (IWMAM001)”.
  6. On same panelid IWMAP01, pull down the “Options” menu.
  7. Enter “1” equal to: “1. Process ISPF list data set”.

  8. A job will be submitted to JES2. Remember the job name to find it in SDSF.

    Instructions following assume SDSF use. Revise independently for IOF, JES Master, etc.

  9. Find the job on the STATUS panel. Put a “?” beside the job, then press Enter.
  10. Locate output data set SYSUT2  PRINTLST,  put an “S” in the NP column, then press <enter>.
  11. Pull down the Print menu.
  12. Enter “2” equal to “2. Print open data set…”.
  13. Fill in “Data set name ===>” enclosing the name in single quotes.
  14. Pull down the “Print” menu. 
  15. Enter “4” equal to “4. Print…”.
  16. Pull down the “Print” menu.
  17. Enter “5” equal to “5. Print close…”.
  18. Now the WLM Policy will be in a data set to be either of the following:
    1. downloaded to PC to be emailed in ASCII format to support@mvssol.com
    2. to be FTP to ftp.mvssol.com in ASCII format

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*