Configure the iStrobe plug-in

The procedures below assume that you have installed the plug-in.

Follow the procedure below to specify the server where is installed so that the plug-in will know which server to connect to.

To specify preferences for the plug-in

Start the Eclipse-based environment in which the plug-in is installed and select Window > Preferences. The Preferences dialog box appears.
Select BMC > iStrobe (or, in Eclipse or RDz, select Preference > iStrobe). The iStrobe - Server Definitions pane appears.
Click Add. The iStrobe: Add Server Definition dialog box appears.
In the Protocol field, choose either http or https.
In the Host field, enter the name of the server where is installed.
In the Port field, enter the port number for the server where is installed.
Optionally, change the name of the web application that appears in the Website field. This name is used in the URL that is used to access . By default, it is set to istrobe during installation.
In the Description field, enter a descriptive name for the server. This is the name you will select from the BMC menu to launch .
Click OK. The server you defined appears in the iStrobe - Server Definitions list on the Preferences dialog box.
Repeat steps 3 through 9 to add additional server definitions if desired.

To edit a server definition

Select the server definition in the iStrobe - Server Definitions list and click Edit. The iStrobe: Edit Server Definition dialog box appears.
Make changes and click OK.

To remove a server definition

Do either of the following:

To remove a single server definition, select the server definition in the iStrobe - Server Definitions list and click Remove.
To remove all server definitions in the list, click Restore Defaults.

To test a server connection

Select the server definition in the iStrobe - Server Definitions list and click Test. A message indicates whether the connection was successful. If it was not, ensure that the data entered is correct and then contact the server administrator if necessary.