Put a Test Case on Hold (ATV)

  1. On the Test Case screen, type H on the command line and press Enter. The Hold Test Case screen is displayed in the following figure.
    Hold Test Case screen

      -------------------------------- Hold Test Case -------------------------------
      Command ===>

       Holding a test case will stop it from running with Playlist
       and ATV runs.

      Test case to be held:
       Name. . . . BATREPL
       Description VALIDATE SYSIN CONTROL CARD PROCESSING FOR BATCH REPLAY JOB

       Press ENTER to hold test case, use END to cancel.

    Your test case status changes to HOLD. You might want to put a test case on hold if the application has changed and the test case requires updates

  2. To change a test case status after you have put it on hold, return to the Test Case screen and type A (Approve) on the Command line. Status will change to APPROVED and the test case can be used.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*