Operator Commands

This section provides the default settings and information about commands that you can use to control operation of the ULTRAOPT subsystem.

You would typically issue these operator commands from the MVS system console. The command syntax uses the following conventions:

  • Items in italics are variables for which you must supply a value. For example, in HALT subsysid, you must supply the correct ULTRAOPT subsystem ID name.
  • When two or more items are separated by a vertical line, you must select only one item. For example, in Z|HALT subsysid,CANCEL, you would use Z or HALT but not both.

This section contains the following topics:


 

  • 4.2
  • 4.2
Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*