Requeuing checkpoint prompt responses
When a REQUEUE TYPE=COLD is initiated through a command set or through the automatic requeue feature, you will receive a BMC43298I WTOR if you specified REQ_PROMPT=YES on the Message Advisor Server Options or on the REQUEUE command set. When a REQUEUE TYPE=REPROCESS or TYPE=EREFAIL is issued, the REQ_PROMPT keyword is ignored. A WTOR is always issued unless an INTERVAL statement is specified and a CHKPT keyword is not specified for TYPE=REPROCESS.
The BMC43298I WTOR is a requeue prompt that is used to verify a checkpoint Message Advisor selects for requeue, initiate a requeue, cancel a requeue, view a list of checkpoints, change a checkpoint, or accept a checkpoint.
BMC Software recommends that you specify REQ_PROMPT=YES if you activate the automatic requeue feature.
As a safety precaution, if you initiate a REQUEUE command set with REQ_PROMPT=NO and the IMS options specify AUTO_REQ=YES, Message Advisor ignores the request and forces the BMC43298I WTOR when the last checkpoint recorded in the Message Advisor checkpoint data set is not a DUMPQ or PURGE.
For information about activating the automatic requeue feature, see Installing. The installation information provides instructions about how to activate the feature at installation and instructions about how to customize Message Advisor online or in batch.
If you initiated a requeue task that specifies REQ_PROMPT=YES, monitor the JES2 job log for the requeue. A prompt similar to the following message is displayed before the requeue is performed:
If you receive a BMC43298I WTOR, you can perform of the following tasks:
Initiate or cancel the requeue.
For instructions about performing this task, see Initiating-or-canceling-a-requeue.
List and change checkpoints for the automatic requeue.
For instructions about performing this task, see Listing-checkpoints-for-automatic-requeue.
This section also contains the following topic:
Related topic